 ROADWARE 10 MINUTE CONCRETE MENDER™
Ultra thin polyurethane for repairing concrete cracks, spalls, and surfaces.
Penetrates deeper than water!
|
| |
Advanced concrete repair material that is easy to apply and stays in place.
Now you can repair cracks and spalls to a smooth finish in a fraction of the time it takes with ordinary products. Roadware 10 Minute Concrete Mender is a revolutionary new two-part hybrid urethane for repairing concrete. It's nearly water thin for deep penetration and it won't pop out like epoxy because it never gets brittle.
No pot-mixing and no waste.
Roadware 10 Minute Concrete Mender is packaged in uniquely designed ratio-packs that completely mix the material at the point of application. No pot-mixing and no unused material. Difficult repairs are now simple, just clean the area, prime with 10 Minute Concrete Mender, add manufactured sand, and flood with additional 10 Minute Concrete Mender. In 10 minutes you'll get a tough 4500 psi polymer concrete that will stay in place permanently.
Great for all industrial floors.
Roadware 10 Minute Concrete Mender is extremely tough and will withstand even the harshest punishment. Great for freezers... may be applied at temperatures as low as -20° F with excellent results. High chemical resistance, perfect for containment areas. Re-coat in 10 minutes, will accept primers and industrial coatings in just 10 minutes after application. Now prep-work and coatings can be applied in the same day!
Roadware 10 Minute Concrete Mender™ is a two-part polyurethane that penetrates deep into concrete to make permanent repairs. At only 8.6 cps, Concrete Mender actually injects itself into the matrix of the concrete and shores up the existing concrete as well as making the repair. Concrete Mender eliminates the bond line and Microdowles into the concrete!
Bulk Mender
http://www.concretemender.com/bulkmender/bulkmender.html
Lessons Learned on a Runway Reconstruction Project
By Peter Florian, Herndon, Virginia 1-703-742-5748
Highlights from the article:
"The American Concrete Paving Association suggested an epoxy injection repair that had been used successfully in Denver to repair shrinkage cracks in a new airport runway surface. With the contractor's help, we identified and tested two possible epoxies. Both manufacturers' representatives demonstrated their products by repairing a dozen cracks each. Post-injection testing was performed by analyzing cores from the test sites.
Based on visual examination of the penetration depth of the material, the polymer product, Roadware 10-Minute Concrete Mender (tm) from Elas-Tech (Roadware Applicator) was selected for further testing. It had penetrated to the bottom of the crack easily with its low coefficient of viscosity. It was also applied easily with an application gun and did not require preparatory steps for the crack. The polymer stained the concrete surface amber, however, so we used cement powder to absorb excess material and minimize staining.
Core samples of the concrete that was uncracked and the concrete that was cracked and sealed with the polymer material were tested for freeze-thaw and scaling resistance. The tests concluded that the concrete core that had been cracked and then sealed with the polymer material exceeded the performance of the uncracked concrete sample.
Repairs Appear to Be Successful
As soon as the client approved the repair method, the contractor applied the material to the cracks in accordance with the manufacturer's instructions and then sprinkled cement powder on top of the uncured polymer to absorb excess material. There was very little evidence of the cracks after cleaning.
A ten-year extended warranty provided by the contractor as a negotiated settlement of this slab cracking calls for annual pavement inspections and for the contractor to make additional repairs as needed. The pavement inspection team has concluded that the pavement remains in an excellent range, with no change in its condition each year since opening to traffic in October of 1997. No additional repairs have been required, and even the surface stains of the concrete are not visible anymore."
 |
Quicktime Movies
You can download a movie that shows Roadware 10 Minute Concrete Mender in action.
Roadware 10 Minute Concrete Mender(tm)
Click on links for download information |
|
Find a qualified contractor for Roadware products
800-500-6402
|
